![]() Does not include white skin that is pictured. The MASCHINE STAND is an essential accessory for anyone using MASCHINE. If you have any questions about this please email us. ![]() Since the panels are wood you may see the slight variations and small flaws in the wood. Please watch the install video shown below to insure that you are installing the panels properly. The Native Instruments Maschine MK3 stand is built to allow you to play comfortably, creating an improved working angle whilst giving your studio a clean and. Being that they are wood, you must be careful to treat them properly. These wooden parts may have slight variations in color and due to the type of Walnut wood that is used some sides can look a bit different than each other. Handmade wooden stand / side parts Duo MIX for Native Instruments Maschine MK1 and MK2 / Maschine Jam MDF anthracite, finely sanded In our Ebay Shop you will. 2 - Support Dowels (not coated or finished, but can be easily painted - these dowels are under the unit and not really seen).The tilt angle is approximately 15 degrees. This kit installs very easily and can be taken on and off very quickly These also have holes where you can install (not included) screws if you want to make them more permanently secure rather than being able to remove easily for transport. Walnut is the same wood used in hight end Bentley and Rolls Royce dashboards!Ĭomplete 2 piece real walnut NI Maschine MK3 wood panel kit along with 2 support dowels and rubber feet for traction on slick areas. Native Instruments Maschine MKIII the classic look with these wood side panels with tilt setup made from real walnut. NI Maschine MK3 Tilt Real Walnut Tilt Stand
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |